Raw data and your own algorithms
Radar Base can stream the radar's raw data (every chirp, both receive channels) over USB. The open firmware includes this stream and its settings; the PC tool for viewing and processing raw data is not published yet.
What the open firmware gives you
| Feature | Where |
|---|---|
| Raw-data settings: chirp, gain, filters, antennas | App → Raw data & radar settings, or console cfg <key> <value> |
| Data-link self-test: every block checked | App → Raw data & radar settings → Run test |
| Results as JSON for your own code | JSON and API |
Where to run an algorithm
Prototype on a PC. Then check whether the radar's own FFT and CFAR hardware can do the job; if so it should run on the radar and only results leave it. Otherwise check the ESP32, and keep it on the PC only if neither fits.
Check the data link
App → Raw data & radar settings → Run test. It runs the raw-data app for a few seconds and checks every block: corrupted and missing blocks should both be 0.
Volume, pre-flashed modules or custom firmware: Kymopsis B2B