Radar Base
Radar Base connects a 60 GHz mmWave radar module to your computer, your phone and your smart home. The radar does the radar work on its own chip; Radar Base loads radar apps into it, turns their results into one simple JSON format, and serves them over USB and Wi-Fi.
Run a ready-made radar appPeople positions in 3D, fall detection, breathing and heart rate. No coding.
Use it in the browser over USBPlug in, open this site in Chrome or Edge, done. No Wi-Fi needed.
Put it on your home Wi-FiReach it at http://kymradar.local from any phone or computer at home.
Build your own integrationRead the results as JSON over USB or WebSocket from any program.
Tested hardware
| Hardware | Status |
|---|---|
| Kymopsis Radar Base dev kit | Tested. Works out of the box; board profile included |
| Kymopsis DIY build: ESP32-S3 DevKit and the 60 GHz radar module on its carrier, wired as in Getting started | Tested. Works out of the box; board profile included |
| Other boards and radar modules | Untested. Check the pin assignment and the board profile yourself; the app then shows "Unknown board, angles not calibrated" |
Open and dev-kit editions
| Feature | Open firmware | Dev-kit firmware |
|---|---|---|
| Run radar apps from the radar's memory, live views | Yes | Yes |
| JSON over USB and Wi-Fi, web app in 11 languages | Yes | Yes |
| Home Wi-Fi, hotspot fallback, Home Assistant (MQTT) | Yes | Yes |
| Raw-data stream, settings and self-test | Yes | Yes |
| Write an app into the radar's own flash, with backup | - | Yes |
| Batch flashing: PASS / FAIL, counter, CSV log | - | Yes |
| Board profile set at the factory | - | Yes |
How it fits together
| Part | What it does |
|---|---|
| Radar module | Runs the radar apps: each app does the whole signal chain on the radar and reports results |
| Radar Base (ESP32-S3) | Loads radar apps, translates results to JSON, streams raw data, serves the web app, joins your Wi-Fi |
| Web app | Pick a task, watch live results, change settings. Same app over Wi-Fi and over USB, in 11 languages |
| Your own code | Reads the JSON results over USB or WebSocket |
| Smart home | Home Assistant over MQTT (auto-discovery), ESPHome component |
Ways to connect
| Mode | When to use it | Guide |
|---|---|---|
| USB | First steps and development. Works anywhere, no network | USB in the browser |
| Home Wi-Fi | Everyday use from phones and computers at home | Home Wi-Fi |
| Hotspot | First setup, or when no home network is reachable | Hotspot fallback |
| Home Assistant | Automations: lights, alerts, dashboards | Home Assistant |
Radar Base never needs a cloud account. Your radar data stays on your own devices.
Volume, pre-flashed modules or custom firmware: Kymopsis B2B