Radar Base in your browser
Connect a Kymopsis Radar Base to use it right here. Nothing is sent to the cloud.
USB needs Chrome or Edge on a desktop computer. On phones and other browsers, use the board over Wi-Fi.
Guides: setup, Home Assistant, ESPHome, JSON ›Choose a scenario
It loads into the radar's memory in about 6 seconds. Power-cycling the radar returns it to the app in its flash.
–
Mounting
Radar outputs
Display
Mounting height
Ceiling mount, facing down. Measure from the floor to the radar.
Radar outputs
For a good reading
Sit or lie still, 0.5–1.5 m in front of the radar, chest facing it. The first values appear after about 20 seconds.
Wellness use only, not a medical device.
Write firmware to the radar
Puts an app into the radar's own flash so it starts by itself at power-up. The current firmware is saved first and can be put back at any time.
Included with the Kymopsis development kit firmware.
This is the open firmware. It runs every radar app from the radar's memory (see Run a scenario) but does not write the radar's flash. Writing needs the dev-kit firmware.
1. Choose the app
Apps are files stored on Radar Base. Add new ones under Device settings → Firmware files.
2. Write
The radar's current firmware is backed up first (saved as bakN.bin). If the backup fails, nothing is written. Takes about 15 seconds.
Progress
Restore a backup
Puts a saved firmware back exactly as it was.
Volume, pre-flashed modules or custom firmware: Kymopsis B2B
About this function
Writing the radar's flash is done by a small closed module that is part of the dev-kit firmware only. That is its only job: it does not connect to the internet and collects no data. Everything else is open source, and every radar app can also run from memory without it.
Batch flashing
Choose a firmware once. Each module is flashed as soon as it is connected; swap modules when the light turns blue.
Included with the Kymopsis development kit firmware.
Write the same firmware to many modules in a row: detect, write, verify, PASS / FAIL, CSV log.
Volume, pre-flashed modules or custom firmware: Kymopsis B2B
Raw data & radar settings
Settings for the raw data stream used by your own algorithms. Live raw data goes to a PC over USB; here you set the radar up and test the data link.
Chirp
Frame period 0 = as fast as possible.
Gain & filters
Antennas
Data-link self-test
Runs the raw-data app for a few seconds and checks every block arriving from the radar.
Device settings
Connect Radar Base to your home Wi-Fi, manage firmware files and check the device.
Home Wi-Fi
–
Once connected, open http://kymradar.local (or the address shown above) from any device on the same Wi-Fi. The Radar Base hotspot only turns on when no home network is saved or it cannot be reached.
Language
Smart home (MQTT)
Send results to your own MQTT broker, for example the Mosquitto add-on in Home Assistant. Radar Base appears in Home Assistant by itself.
–
Leave empty to keep the saved password.
This device
Firmware files
Radar apps and backups stored on Radar Base.
Diagnostics
Quick checks when something does not work. The log below shows what Radar Base and the radar report.